How to Fix Stone Chips with Touch-Up Paint

Stone chips are part of life on Australian roads. Left alone, a chip through to bare metal will start to rust. The good news is that most chips can be fixed at home in under an hour with touch-up paint mixed to your car's code.
What you need
- Touch-up paint mixed to your paint code. Check the code on your car first: where to find your paint code.
- Wax and grease remover, or a degreaser such as Mipa silicone remover.
- A fine artist's brush or a toothpick for small chips.
- Primer if the chip is down to bare metal: see our primers.
- Clear coat for metallic and pearl colours: see our clear coats.
- Fine wet-and-dry paper (1500 to 2000 grit) and polish, if you want a flush finish.
Step 1: Clean the area
Wash the panel and let it dry. Wipe the chip and the area around it with degreaser. Wax and road grime stop paint from sticking.
Step 2: Remove loose paint and rust
Gently lift any loose flakes with the tip of a blade. If there is surface rust, take it back to clean metal with a fibreglass pen or fine abrasive. Keep the repair as small as you can.
Step 3: Prime bare metal
If you can see bare metal, dab a little primer into the chip only. Let it dry as the label says.
Step 4: Apply colour in thin layers
Shake the can well. For small chips, spray a little paint into the cap or onto a piece of card and dab it into the chip with a fine brush or toothpick. Build it up in thin layers, letting each one dry, until the chip is level with the paint around it. Thin layers dry harder and look better than one thick blob.
For a cluster of chips or a larger area, spray from about 20 to 25cm in light passes, masking off the rest of the panel first.
Step 5: Clear coat (metallic and pearl colours)
Metallic and pearl basecoats dry flat. Once the colour is dry, apply clear coat the same way to bring back the gloss and protect the repair.
Step 6: Level and polish (optional)
After the paint has fully cured (give it at least a few days), you can wet-sand any raised edge lightly with 2000 grit and polish the area to blend it in. See How to Choose Sandpaper Grits for Car Paint Repairs.
Common mistakes to avoid
- Ordering by colour name instead of paint code. Read why we mix to your paint code.
- Painting in direct sun or on a hot panel.
- Putting on too much paint at once.
- Skipping primer on bare metal, which lets rust creep back.
Get your touch-up paint
We mix touch-up aerosols to any factory code: find your make on our paint code aerosols page. Popular colours include Toyota Glacier White (040) and Hyundai Phantom Black (PAE). A 400ml can is $35, delivered within Victoria (interstate customers please call (03) 9396 8096), or collect from 14 Zal Street, Melton.






